-
Toy Projectile Range Tester GT-M86
Applications: Discharge the projectile in any reasonably foreseeable manner that will maximize the distance travelled (typically 45°). At the point of discharge the projectile shall be disengaged from the discharge mechanism and in free flight. If the maximum distance is in the horizontal plane, the distance is measured from the point of discharge 1Read More -
Toys Kinetic Energy Tester New GT-M18B
Kinetic Energy tester is used to detect the maximum kinetic energy generated by the fired bullets of Projectile toys or the launched bows. It meets standards: ISO 8124-1, GB6675-2, EN-71-1, ASTM F963.Read More -
Overload Test Loads For Ride-On Toys And Seats GT-MA17
Overload Test Loads For Ride-On Toys And Seats is mainly used for the overload capability test of ride-on toys.Read More -
Toy Handlebar Resistance To Separation Tester GT-M94
Toy Handlebar Resistance To Separation Tester is used to test the anti-separation performance of toy handlebars. Standards: ISO 8124-1 5.30.Read More -
Toy Chest Lid Durability Tester GT-M02
Toys Chest Lid Tester applies to test the durability of toys box cover. It uses fixtures to drive the toy box cover move, after simulating a certain number of opening and closing movements, check whether the toy box lid hinge part’s functions are in good condition.Read More -
Mouth-actuated Catapult Toy Endurance Tester GT-M04
This Mouth-actuated Catapult Toy Endurance Tester GT-M04 is used to test mouth-actuated projectile toys’ blowing resistant properties.Read More -
Toys Scooter Steering Tubes Strength Tester GT-M82
Toys Scooter Steering Tubes Strength Tester apply to test the strength of toy scooter steering tubes,including resistance to downward forces and resistance to upward forces.Read More -
EN71-2 ISO 8124 Toys Flammability Tester GT-M17
Toys Flammability Tester GT-M17 is used to test children apparel or toy and its decorations flammability performance, to evaluate the burning speed and time of the following kinds of toys.Read More -
Tumble Test Steps for Wheeled Toys GT-M91
Tumble Test Steps for Wheeled Toys is mainly used to tumble test for Wheeled toys weighing more than 3 lb (1.4 kg) but not more than 10 lb (4.5 kg). Standards: ASTM F963 section 8.7.3.Read More -
Toys Testing Sharp Point Tester GT-MB04
Sharp Point Tester is used to determinate that points on toys and other articles intended for use by children under 8 years of age.Read More